TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 450 of 783

TM 9-2350-260-20-1-3

SHIFT LINKAGE ADJUSTMENT (Sheet 18 of 20)

135.

Using small diameter wire, check to see if shifting

rod (BQ) is past holes (BR) and (BS).

If shifting

rod (BQ) is past holes (BR) and (BS), do steps

136 thru 139.

If shifting rod (BQ) is not past hole

(BR), do steps 140 through 149.

If shifting rod

(BQ) is not past hole (BS), go on to step 150.

TOP OF TRANSMISSION

136.

Using 9/16 inch wrench, install screw (F) through

clevis (H) and shifting rod bearing end (G).

137.

Using 9/16 inch wrench, tighten jamnuts (BT) and

(BU).

138.

Remove locating pin from alinement hole (C).

139.

Using 9/16 inch socket and torque wrench, tighten

screw (F) to 15-20 lb-ft (20-27 N

•

m) and go to step

160.

140.

Using 9/16 inch wrench, adjust shifting rod bearing

end (G) by turning clockwise until shifting rod (BQ)

is past hole (BR).

141.

Using 9/16 inch wrench, remove screw (BV) and remove shifting rod bearing end (BW) from clevis (BX).

142.

Using 9/16 inch wrench, install screw (F) through clevis (H) and shifting rod bearing end (G).

143.

Using 9/16 inch wrench, tighten jamnut (B).

144.

Using 9/16 inch socket and torque wrench, tighten screw (F) to 15-20 lb-ft (20-27 N

•

m).

Go on to Sheet 19

TA146573

11-19