TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 445 of 783
TM 9-2350-260-20-1-3
SHIFT LINKAGE ADJUSTMENT (Sheet 13 of 20)
87. Using 9/16 inch wrench, adjust shifting rod bearing
end (AX) by turning clockwise until shifting rod (AY)
is past hole (AZ).
88. Using 9/16 inch wrench, remove screw (BB) 89.
Using 9/16 inch wrench, install screw (AV) through
clevis (AW), and shifting rod bearing end (AX).
90. Using 9/16 inch wrench, tighten jamnut (AT).
RIGHT REAR OF
ENGINE COMPARTMENT.
91. Using 9/16 inch socket and torque wrench, tighten
screw (AV) to 15-20 lb-ft (20-27 N
•
m).
92. Using 9/16 inch wrench, adjust shifting rod bearing
end (BC) by turning clockwise or counterclockwise
until screw (BB) will drop freely through clevis (AH)
and shifting rod beating end (BC).
93. Using 9/16 inch wrench, install screw (BB).
94. Using 9/16 inch wrench, tighten jamnut (AU) and remove locating pin from alignment hole (AS).
95. Using 9/16 inch socket and torque wrench, tighten screw (BB) to 15-20 lb-ft (20-27 N
•
m) and go on to step 106.
96. Using 9/16 inch wrench, remove screw (BB).
97. Using 9/16 inch wrench, adjust shifting rod beating end (BC) by turning clockwise until shifting rod (AY) is past hole
(BA).
Go on to Sheet 14
TA146568
11-14
Back to Top
