TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 452 of 783

TM 9-2350-260-20-1-3

SHIFT LINKAGE ADJUSTMENT (Sheet 20 of 20)

NOTE

It may be necessary to move

indicator pointer to most rear-

positioned dot to adjust rod end, and

then back to most forward-positioned

dot to check adjustment in step 155.

155.

Using 9/16 inch wrench, adjust shifting rod bearing

end (G) by turning clockwise or counterclockwise

until screw (F) will drop freely through clevis (H)

and shifting rod bearing end (G).

156.

Using 9/16 inch wrench, install screw (F) through

clevis (H) and shifting rod bearing end (G).

157.

Using 9/16 inch wrench, tighten jamnut (BT).

158.

Remove locating pin from alinement hole (C).

159.

Using 9/16 inch socket and torque wrench, tighten screw (F) to 15-20 lb-ft (20-27 N

•

m).

160.

Install right hull ammo rack (page 17-16).

161.

Check shifting pattern response (TM 9-2350-260-10).

If transmission still does not shift correctly, notify support

maintenance.

If transmission does shift correctly, go on to step 162.

162.

Install top deck (page 16-22).

163.

Install transmission shroud (page 9-23).

TA146575

End of Task

11-21