TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 459 of 783

TM 9-2350-260-20-1-3

SHIFTING CONTROL BASE ASSEMBLY REPAIR AND REPLACEMENT (Sheet 4 of 6)

CLEANING AND INSPECTION:

1.

Using rags and dry cleaning solvent (Item 54, Appendix D), clean bearing surface of base and shaft.

2.

Inspect base, shaft, pivot, link, guide, quadrant link, and pins for cracks or damage.

Replace part as necessary.

INSTALLATION:

1.

With base (A) in vise and using hammer and drift, install new bearing (B) into base (A).

2.

Remove base (A) from vise.

3.

Using hand, position pivot (C) into base (A) and

install shaft (D) through base (A) and pivot (C).

4.

Aline holes in pivot (C) with hole in shaft (D).

5.

Using hammer, install pin (E) through pivot (C) and shaft (D).

6.

Position guide (F) onto base (A).

Using 1/2 inch socket, install three screws (G) and new lockwashers (H) securing

guide (F) to base (A).

Go on to Sheet 5

TA146582

11-28