TM-9-2350-260-20-1-3
TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)
TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15
TM-9-2350-260-20-1-3 - Page 441 of 783
TM 9-2350-260-20-1-3
SHIFT LINKAGE ADJUSTMENT (Sheet 9 of 20)
49. Using 9/16 inch wrench, adjust shifting rod bearing
end (AG) by turning clockwise or counterclockwise
until screw (AF) will drop freely through clevis (AH)
and shifting rod bearing end (AG).
50. Using small diameter wire (Item 82, Appendix D),
check to see if shifting rod (AJ) is past holes (AK)
and (AL).
If shifting rod (AJ) is past holes (AK) and
(AL), do steps 51 through 53.
If shifting rod (AJ) is
not past hole (AK), do steps 54 through 62.
If
shifting rod (AJ) is not past hole (AL), go to step 63.
51. Using 9/16 inch wrench, install screw (AF) through
clevis (AH) and shifting rod bearing end (AG).
52. Using 9/16 inch wrench, tighten jamnuts (AD) and
(AE) and remove locating pin from alignment hole
(AC).
53. Using 9/16 inch socket and torque wrench, tighten
screw (AF) to 15-20 lb-ft (20-27 N
•
m) and go on to
step 73.
54. Using 9/16 inch wrench, adjust shifting rod bearing
end (AG) clockwise until shifting rod (AJ) is past hole
(AK).
55. Using 9/16 inch wrench, remove screw (AM).
56. Using 9/16 inch wrench, install screw (AF) through clevis (AH) and shifting rod bearing end (AG).
57. Using 9/16 inch wrench, tighten jamnut (AD).
58. Using 9/16 inch socket and torque wrench, tighten screw (AF) to 15-20 lb-ft (20-27 N
•
m).
Go on to Sheet 10
TA146564
11-10
Back to Top
