TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 703 of 783

TM 9-2350-260-20-1-3

COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 4 of 5)

1.

Apply a light coat of grease (Item 36, Appendix D) to

outside of seal (A) .

2.

Position new outer grease seal (A) into retainer

(B)

so BACK of seal is into retainer and FRONT is

facing away from retainer.

6.

Slide seal retainer (B) over upper spindle and

replacer until It is seated on spacer (C) .

3.

Using replacer and handle (Item 19 and 9,

Chapter 3, Section I) , tap seal (A) into place in seal

retainer (B) .

4.

Coat upper spindle or arm, replacer, and seal

retainer (B) with grease (Item 36, Appendix D) .

5.

Position replacer (Item 22, Chapter 3, Section I) on

upper spindle, flush with spacer (C) .

Go on to Sheet 5

TA147871

14-70