TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 704 of 783

TM 9-2350-260-20-1-3

COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 5 of 5)

7.

Remove replacer from upper spindle.

8.

Apply light coat of grease to outer bearing (D) , bearing spacer (E) , and inner bearing (F).

Install them on arm upper

spindle.

9.

Install bearing washer (G) , key washer (H) with tabs toward nut (J) , and screw nut (J) onto end of upper spindle.

10. Using spanner wrench (Item 25, Chapter 3, Section I) tighten nut (J) until bearing assembly cannot be turned.

11. Back nut (J) off just enough so bearing assembly can be turned by hand through one complete turn on spindle.

12. Using hammer and punch, bend tab of key washer

(H) so it fits in one of our slots in nut (J) .

13. Service hub and arm assembly (LO 9-2350-260-12).

14. Install

compensating

idler

arm

assembly

(page 14-16) .

End of Task

TA147872

14-71