TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 701 of 783

TM 9-2350-260-20-1-3

COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 2 of 5)

DISASSEMBLY:

1.

Using hammer and punch, bend tabs of key washer

(A) back from nut (B) .

2.

Using spindle nut wrench (Item 25, Chapter 3

Section I) , loosen nut (B) .

3.

Remove nut (B) , key washer (A), bearing washer

(C , and inner bearing (D) from upper spindle of arm.

ROADWHEEL ARM

NOTE

It may be necessary to tap oil seal retainer (G) lightly with hammer to aid in

removing outer bearing (F) .

4.

Remove spacer (E) and outer bearing (F) from upper spindle.

5.

Slide oil seal retainer (G) off upper spindle.

6.

Using screwdriver, pry

seal (H) out of retainer (G) .

Throw seal away.

Go on to Sheet 3

TA147869

14-68