TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

  TM-9-2350-260-20-1-3 - Page 691 of 783

TM 9-2350-260-20-1-3
GREASE ACTUATED TRACK ADJUSTING LINK REPLACEMENT (Sheet 6 of 7)
7.
Install flat washer (J) and nut (K) on threaded end of
pin assembly (B) .
8.
Using 1-1/8 inch socket, tighten nut (K) and align
slot in nut (K) with hole in pin assembly (B) .
9.
Using pliers, install new cotter pin (L) .
10. Using wire rope assembly (M) and lifting device,
lower compensating idler arm (A) .
13. Using torque wrench, tighten capscrews (Q)
150-200 lb.ft.
(203-271 N
m) .
14. Remove wire rope assembly (M) and lifting device.
11. Aline slots of yoke (D) on adjusting link (C) with
bearing (N) on number 1 roadwheel support arm (P).
12. Using 15/16 inch socket and extension, install and
tighten two capscrews (Q) to secure adjusting link
(C) to bearing (N) .
Go on to Sheet 7
TA248466
Change 1
14-64.5


Back to Top