TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 700 of 783

TM 9-2350-260-20-1-3

COMPENSATING IDLER ARM ASSEMBLY REPAIR (Sheet 1 of 5)

PROCEDURE INDEX

PROCEDURE

PAGE

Disassembly

14-68

Cleaning and Inspection

14-69

Assembly

14-69

TOOLS:

9/16 in.

socket with 1/2 in.

drive

Pinch bar

Drift punch

Ratchet with 3/4 in.

drive

Ratchet with 1/2 in.

drive

Impact wrench with 1 in.

drive

Hammer

Flat-tip screwdriver

1/2 in.

hinged handle

Torque wrench with 3/4 in.

drive (0-600 lb-ft)

(0-814 N

•

m)

Needle nose pliers

2-1/2 in.

socket with 1 in.

drive

SPECIAL TOOLS:

Handle, remover and replacer (Item 9, Chapter 3, Section I)

Replacer, oil seal (Item 19, Chapter 3, Section I)

Replacer, oil seal and retainer (Item 22, Chapter 3, Section I)

Wrench, hook spanner (Item 25, Chapter 3, Section I)

SUPPLIES:

Grease (Item 36, Appendix D)

Seal (MS51912-2-9)

REFERENCES:

TM 9-2350-260-10

LO 9-2350-260-12

PRELIMINARY PROCEDURE:

Remove compensating idler arm assembly (page 14-64)

Go on to Sheet 2

TA147868

14-67