TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 810 of 1008

TM 9-2350-261-20-2

REPLACE STEERING LEVERS CROSS-SHAFTS AND BEARINGS — Continued

0390 00

INSTALLATION

NOTE

If arm bearing (1) is to be replaced, use shim (2) as a template to locate and drill two .250-.252

inch (6 mm) holes in base of new bearing before installation. If there is no shim, make template

from old bearing.

1.

Assemble cross-shaft (3), cross-shaft (4), arm bearing (1), lube fittings (5), and two thrust washers (6) as a unit. Install

through power plant compartment bulkhead opening.

2.

Place shim (2) and bearing (1) on bracket (7). Secure with two new tapered pins (8), new locknuts (9), washers (10), and

screws (11).

3.

Install two clevises (12) on cross-shaft (3) and cross-shaft (4). Secure with two clevis pins (13), washers (14) and

new cotter pins (15).

4.

Install new gasket (16), cover (17), and cover (18) on five press nuts (19) in power plant compartment bulkhead. Secure

with five new locknuts (20), screws (21), and washers (22).

5.

Install bearing (23) in bracket (24). Secure with two retaining rings (25). Use snap ring pliers.

6.

Install two quadrants (26) and stops (27) on bracket (24). Secure with two screws (28) and new locknuts (29).

0390 00-4