TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 818 of 1008

TM 9-2350-261-20-2

REPLACE DIFFERENTIAL CROSS-SHAFTS AND BEARINGS — Continued

0392 00

INSTALLATION

1.

Install bearing (9) in bearing (1). Secure with two retaining rings (8).

2.

Install lubrication fitting (10) in bearing (1).

3.

Assemble cross-shaft (2), cross-shaft (5), two bearings (6), two thrust washers (7), bearing (1), woodruff key (11),

andlinkarm(12)

.

4.

Install screw (13) and new locknut (14) in link arm (12). Do not tighten nut.

5.

Place cross-shaft (2), cross-shaft (5), two bearings (6), and bearing (1) as a unit on two brackets (15).

6.

Install two bearings (6) on two brackets (15). Secure with four screws (16), washers (17), and new locknuts (18).

7.

Install bearing (1) and shim (19) to driver’s compartment bulkhead. Secure with two screws (20), four washers (21),

and two new locknuts (22).

8.

Install four links (23) to cross-shaft (2), cross-shaft (5), and link arm (12). Secure with four clevis pins (24) and new

cotter pins (25).

9.

Tighten four set screws (3) in two bearing collars (4).

10. Tighten nut (14) on link arm (12).

0392 00-4