TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 863 of 1008

TM 9-2350-261-20-2

REPLACE FUEL CUTOFF CONTROL CABLE ASSEMBLY — Continued

0403 00

7.

Insert control assembly (1) through engine bracket (2).

8.

Install rear collar (3) on control assembly (1).

9.

Insert control assembly (1) through pin (4).

10. Install front collar (5) on control assembly (1) with two set screws (6) and (7).

11. Secure collars (3) and (5) on control assembly (1) with two set screws (6) and (7).

12. Install control assembly (1) on engine bracket (8). Secure with clamp (9), screw (10), and new locknut (11).

13. Install control assembly (1) on engine bracket (2). Secure with screw (12) and new locknut (13).

ADJUSTMENT

1.

Loosen two set screws (6) and (7) in collars (3) and (5).

2.

Pull control assembly handle (14) to full out position.

3.

Rotate fuel control arm (15) to full clockwise position.

4.

Place two collars (3) and (5) on each side of pin (4). Secure with two set screws (6) and (7).

FOLLOW-THROUGH STEPS

1.

Install power plant rear access panel (WP 0431 00, WP 0432 00, or WP 0433 00).

2.

Start your engine (see your -10). Check that fuel shutoff cable operates properly.

3.

Close power plant front access door and raise trim vane (see your -10).

4.

Raise and lock ramp (see your -10).

5.

Stop/shutdown engine (see your -10).

END OFTASK

0403 00-5/6 blank