TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 856 of 1008

TM 9-2350-261-20-2

REPLACE HAND THROTTLE — Continued

0402 00

REMOVAL

1.

Remove two screws (1), washers (2), and four clamps (3) that secure throttle control cable assembly (4) to two weldnuts

(5).

2.

Remove two screws (6), locknut (7), lockwasher (8), two straps (9), and cable assembly (4) from weldnut (10). Discard

locknut and lockwasher.

3.

Rem ove cotter pin (11) and w asher (12). Disconnect pin ( 13) from accelerator

ped al assem bly (14 )

.

D iscard cotter pin.

4.

Loosen set screw (15). Remove collar (16) and pin (13) from cable assembly (4).

5.

Pull cable assembly (4) through grommet (17) in driver’s floor plate and out through power plant front access door

opening. Discard grommet.

6.

Remove nut (18) and washer (19) that secure cable assembly (4) to driver’s compartment bulkhead.

7.

Remove cable assembly (4) from driver’s compartment.

0402 00-2