TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 857 of 1008

TM 9-2350-261-20-2

REPLACE HAND THROTTLE — Continued

0402 00

INSTALLATION

1.

Install new grommet (1) in driver’s floor plate.

2.

Feed cable assembly (2) through mounting hole in driver’s compartment bulkhead to power plant front access door

opening.

3.

Slide washer (3) and nut (4) on cable assembly (2). Secure to driver’s compartment bulkhead.

4.

Install cable assembly (2) on two weldnuts (5). Secure with two washers (6), screws (7), and four clamps (8).

5.

Install cable assembly (2) on weldnut (9). Secure with two straps (10), screws (11), new lockwasher (12), and new

locknut (13).

6.

Install pin (14) on accelerator pedal assembly (15). Secure with washer (16) and new cotter pin (17).

7.

Install cable assembly (2) on pin (14). Secure with collar (18) and set screw (19).

ADJUSTMENT

1.

Loosen set screw (19). Push control cable assembly (2) handle full forward.

2.

Place pedal assembly (15) in full closed throttle position (see your -10). Tighten set screw (19) in collar (18).

FOLLOW-THROUGH STEPS

1.

Start engine (see your -10). Using the pedal, check that hand throttle operates properly.

2.

Stop/shutdown engine (see your -10)

3.

Close power plant front access door (see your -10).

4.

Raisetrimvane(seeyour-10)

.

5.

Install driver’s power plant access panel (see your -10).

END OFTASK

0402 00-3/4 blank