TM 9-2350-261-20-3
REPLACE POWER PLANT REAR ACCESS PANELS (M113A2
AND M901A1 ONLY)
0431 00
THIS WORK PACKAGE COVERS:
Removal (page 0431 00-1).
Installation (page 0431 00-2).
INITIAL SETUP:
Maintenance Level
Unit
Tools and Special Tools
General Mechanic’s Tool Kit (WP 0780 00, Item 29)
Materials/Parts
Cotter pin (7)
Locknut (6)
Personnel Required
Unit Mechanic
References
WP 0120 00
Equipment Condition
Engine stopped/shutdown (see your -10)
Carrier blocked (see your -10)
Personnel heater duct removed (WP 0617 00)
REMOVAL
1.
Unscrew seven T-bolts (1). Remove upper and lower panels (2) and (3).
NOTE
Remove seals only if damaged.
2.
Bend back seal supports on panel to remove seals (4) and (5).
3.
Remove seven cotter pins (6), T-bolts (1), washers (7), and clamps (8) from hull. Discard cotter pins.
4.
Remove seven screws (9) and spacers (10) from hull.
5.
Remove two locknuts (11), screws (12), and cover (13) from hull. Discard locknuts.
6.
Remove four locknuts (14), screws (15), and support (16) from hull. Discard locknuts.
043100-1