TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 59 of 932
TM 9-2350-261-20-3
REPLACE POWER PLANT REAR ACCESS PANELS (M1059 ONLY) — Continued
0432 00
INSTALLATION
1.
Install four screws (1), nuts (2), two plates (3), and brackets (4) and (5) on upper panel (6).
2.
Install rifle clip (7), screw (8), and nut (9) on bracket (5).
3.
Install rifle bracket (10), two screws (11), and nuts (12) on bracket (4).
4.
Install support (13) on hull. Secure with four screws (14) and new locknuts (15).
5.
Install cover (16) on hull. Secure with two screws (17) and new locknuts (18).
6.
Install seven spacers (19) on hull. Secure with seven screws (20).
7.
Install seven clamps (21), washers (22), T-bolts (23), and new cotter pins (24) in hull.
8.
If removed, install new seals (25) and (26) on panels (6) and (27). Bend seal supports to secure seals to panels.
9.
Install panels (6) and (27) on hull. Tighten seven clamps (21) and T-bolts (23).
10. Use chalk test (WP 0120 00) to ensure panel seals hull opening to prevent carbon monoxide leaks.
FOLLOW-THROUGH STEPS
1.
Install personnel heater duct (WP 0617 00).
END OF TASK
0432 00-3/4 blank
Back to Top
