TM-9-2350-261-20-3
CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 3 OF 4
TM-9-2350-261-20-3 - Page 52 of 932
TM 9-2350-261-20-3
REPLACE HULL FRONT ACCESS COVER — Continued
0429 00
INSTALLATION
WARNING
Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These
compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you
dizzy and irritate your eyes and throat.
Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.
Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.
1.
Apply thin coat of adhesive to one side of new gasket (4), if gasket is being replaced, and allow to dry 20-40 minutes.
Apply thin coat of adhesive to cleaned bottom side of cover. Allow to dry 30-120 seconds.
2.
Position gasket (4) on cleaned bottom side of cover (3). Align mounting holes in cover and gasket.
3.
Secure cover (3) and gasket (4) to hull with four washers (2) and screws (1). TIGHTEN SCREWS TO 40–50 LB-FT
(54–68 N·M) TORQUE. Use torque wrench.
FOLLOW-THROUGH STEPS
1.
Raise trim vane (see your -10).
END OF TASK
0429 00-2
Back to Top
