TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 687 of 871

TM 9-2350-277-34

REPLACE INVERTER AND INVERTER HOUSING ASSEMBLY A2 (M1068A3

ONLY) (OUTBACK ONLY) — Continued

0094 01

WARNING

Each Outback inverter assembly weighs 70 lbs (32 kg) and may be awkward to handle. Use

correct lifting procedures, indicated lifting devices, and/or assistance from other personnel to

avoid injury. Failure to comply could result in injury to personnel and equipment damage.

NOTE

Both inverters are identical, however due to space constraints, one of the inverters must

be mounted upside down.

21. Slide inverter mount assembly (33) completely into inverter housing (32). Have helper assist.

22. Install three cap screws (34), new lockwashers (35), and flat washers (36) securing inverter mount assembly (33)

to inverter housing (32).

23. If necessary, repeat Steps 6 - 21 for inverter (IN2).

0094 01-20

Change 5