TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 682 of 871

TM 9-2350-277-34

REPLACE INVERTER AND INVERTER HOUSING ASSEMBLY A2 (M1068A3

ONLY) (OUTBACK ONLY) — Continued

0094 01

WARNING

Each Outback inverter assembly weighs 70 lbs (32 kg) and may be awkward to handle. Use

correct lifting procedures, indicated lifting devices, and/or assistance from other personnel to

avoid injury. Failure to comply could result in injury to personnel and equipment damage.

6.

Position inverter (31) on mount (65) and secure using six cap screws (63), flat washers (64), and new locknuts (67).

7.

Place bracket (60) over inverter (31) and secure to mount (65) using two cap screws (61), four flat washers (62), and two

new locknuts (66).

8.

Slide inverter mount assembly (33) into inverter housing (32). Have helper assist. Slide and position inverter halfway

into housing to allow room for cable routing and connection.

0094 01-15

Change 5