TM-9-2350-277-34

CARRIER M113A3, M577A3, M1059A3, M1064A3, M1068A3 AND M58

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-277-34 - Page 676 of 871

TM 9-2350-277-34

REPLACE INVERTER AND INVERTER HOUSING ASSEMBLY A2 (M1068A3

ONLY) (OUTBACK ONLY) — Continued

0094 01

WARNING

Each Outback inverter assembly weighs 70 lbs (32 kg) and may be awkward to handle. Use

correct lifting procedures, indicated lifting devices, and/or assistance from other personnel to

avoid injury. Failure to comply could result in injury to personnel and equipment damage.

23. Slide and remove inverter mount assembly (33) from inverter housing (32). Have helper assist.

24. Remove two locknuts (66), four flat washers (62), two cap screws (61), and bracket (60) securing inverter (31) to

mount (65). Discard locknuts.

25. Remove six locknuts (67), flat washers (64), and cap screws (63) securing inverter (31) to mount (65). Remove inverter

from mount and discard locknuts.

26. If necessary, repeat Steps 11 - 25 for inverter (IN2).

009401-9

Change 5