TM-9-2350-311-20-2
HOWITZER, MEDIUM, SELF-PROPELLED, 155MM; M109A2, M109A3, M109A4 AND M109A5
TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL FOR CAB, ARMAMENT, SIGHTING AND FIRE CONTROL, ELEVATING AND TRAVERSING SYSTEMS AND ASSOCIATED COMPONENTS
DECEMBER 1993
TM-9-2350-311-20-2 - Page 430 of 828
TM 9–2350–311–20–2
8–6
8–1
WIRING HARNESS AND CABLE REPAIR — CONTINUED
d.
Female-Type Panel Mounting Receptacle with Ridged Locking Nut
1
Disassembly
(a)
Unscrew nut (1) from shell (2) and slide back on cable leads (3).
(b)
Slide grommet (4) back on cable leads (3).
(c)
Push socket contacts (5) out through rear of insert (6) with pin extractor.
(d)
Slide insert (6) out through rear of shell (2).
(e)
Unsolder cable leads (3) from solder wells of socket contacts (5).
2
Assembly
(a)
Strip cable insulation equal to depth of solder wells of socket contacts (5).
(b)
Slide nut (1) over cable leads (3).
(c)
Slide grommet (4) over cable leads (3).
NOTE
Use rosin core solder only. For soldering instructions, refer to para 2–16.
(d)
Insert cable leads (3) into solder wells of socket contacts (5) and solder.
(e)
Push insert (6) into shell (2) from rear until seated. Groove (7) in insert (6) must be alined with guide in
shell (2) to ensure proper fit.
(f)
Push socket contacts (5) into insert (6) from rear until seated.
(g)
Push grommet (4) down cable leads (3) and over solder wells of socket contacts (5).
(h)
Screw nut (1) onto shell (2).
(i)
Tape wire as required.
2
6
5
3
1
4
7
Back to Top
