TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 309 of 933

TM 9-2520-270-34

CAUTION

Clamps must be installed on straight section

of hose. Hose must not sag or contact any

parts in transmission. Damage to equipment

can occur.

27. POSITION THREE CLAMPS (1).

PULL HOSE (2) TIGHT BETWEEN

CLAMPS, USING 3/8-lNCH DRIVE

RATCHET HANDLE AND 5/32-lNCH

SOCKET WRENCH ATTACHMENT,

INSTALL THREE NEW SCREWS (3).

28.

29.

HOLD HOSE (2) TIGHT BETWEEN

CLAMPS (1). USING 3/8-lNCH DRIVE

TORQUE WRENCH AND 5/32-lNCH

SOCKET WRENCH ATTACHMENT,

TORQUE THREE SCREWS (3) TO

35-45 in-lb (40-52 cmkg).

USING WIRE-TWISTER PLIERS,

INSTALL THREE NEW LOCKWIRES (4)

IN SCREWS (3) AND AROUND

CLAMPS (1).

30. DELETED.

31. INSTALL POSITIVE CLUTCH.

See task REPLACE POSITIVE

33.

CLUTCH, page 4-356.

32. INSTALL LEFT-HAND INTERMEDIATE

HOUSING ASSEMBLY. See task

34.

REPLACE LEFT-HAND INTERMEDIATE

HOUSING ASSEMBLY, page 4-220.

INSTALL LEFT-HAND OUTPUT

HOUSING. See task REPLACE LEFT-

HAND OUTPUT HOUSING, page 4-314.

INSTALL CONTROLLER ASSEMBLY.

See task REPLACE CONTROLLER

ASSEMBLY, page 3-32.

END OF SUBTASK

Change 3

4-13