TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 541 of 779

d. Time Totalizing Meter.

Refer to figures 5-

5 , 5-4, and 4-10.

Note.

After installing time totalizing meter on

engine, the engine name plate must be stamped

with an “X” after the engine serial number. This

will show engine has a time totalizing meter

installed. The time totalizing meter must be set

back to zero (para 6-70b) before being installed.

e. Generator and Associated Parts.

Refer to

figures 7-35, 4-17 through 4-13, and figure 4-11.

1.

2.

3.

4.

Position cradle (A) on generator support,

Install two self-locking nuts (B) and flat washers but do

not tighten.

Install clamping bar (C) on “U” bolt.

Install self-locking nut (D). Tighten nut until ap-

proximately ~8 -inch of bolt is exposed through the nut.

This is the approximate position of nut after “U” bolt

has been positioned over the generator, prior to in-

stalling the outside bar and nut.

Note.

The preformed packing (fig. 4-12) is a

generator part and must be in place before in-

stalling generator air intake tube.

Figure 7-35. Assembling generator cradle,

support, and “U’’ bolt.

f. Test and Adjustments.

After the egine has

been

completely

assembled

it

should be tested

and the necessary adjustments made as directed

in Chapter 8 of this manual.

7-2 9