TM-9-2815-205-24

6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L

TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE

FEBRUARY 2013

TM-9-2815-205-24 - Page 114 of 856

REMOVAL

1.

Remove two screws (Figure 1, Item 5) and two flat washers (Figure 1, Item 4) securing idler pulley assembly

(Figure 1, Item 7) to engine.

2.

Remove idler pulley assembly (Figure 1, Item 7) and two drive belts (Figure 1, Item 6).

NOTE

For models 5063-5393 and 5063-539L, water by-pass hose and two clamps were removed

in (WP 0011).

3.

Loosen two hose clamps (Figure 1, Item 3) securing hose (Figure 1, Item 2) to coolant pump

(Figure 1, Item 8) and water by-pass tube (Figure 1, Item 1). Slide hose and clamps onto coolant pump.

1

2

3

4

5

5

6

4

7

8

MAINT_027

Figure 1.

Coolant Pump Idler Pulley and Belts Removal.

NOTE

For model 5063-5393, it will be necessary to remove fuel line clamp from screw at front

lower position of coolant pump mounting to oil cooler. It may also be necessary to

disconnect the fuel line, routed across the front of the coolant pump, from the fuel junction

block in (WP 0012).

4.

Remove four screws (Figure 2, Item 10), four lockwashers (Figure 2, Item 11), four flat washers

(Figure 2, Item 12), and socket head screw (Figure 2, Item 9), securing coolant pump (Figure 2, Item 8) to

oil cooler (Figure 1, Item 14). Discard lockwashers.

5.

Remove coolant pump (Figure 2, Item 8) and gasket (Figure 2, Item 13). Discard gasket.

6.

For all except models 5063-5393 and 5063-539L, remove hose (Figure 2, Item 2) and two clamps

(Figure 2, Item 3) from coolant pump (Figure 2, Item 8).

END OF TASK

TM 9-2815-205-24

0013

0013-2