TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 105 of 596

TM 9-2815-205-34

2-30. ENGINE FROM/TO CONTAINER (Model 5063-5299) (Cont)

b. Installation

(1)

(2)

(3)

Never crawl under

equipment when performing maintenance unless

equipment

is securely blocked.

Keep clear of equipment when it is being raised or lowered.

Do not allow heavy components to swing while suspended by lifting device.

Exercise caution when worklng

near a cable or a chain under tension.

Equipment may drop or shift and injury to personnel may result.

Attach a beam-type sling (1) to lifting brackets (2) and support engine with lifting device.

Remove mailbag (26) and engine support (15) from bottom of container. Remove screws,

washers, and nuts from mailbag.

NOT E

Use two flat washers (27) between engine boss and engine support (15) to mount

engines with serial numbers up to 6D-16046 only. When not used, secure extra

washers to support with locking wire or tape.

Install two screws (23), four flat washers (24), engine support (15), and two nuts (25) to rear of

engine. Install two screws (20), four flat washers (21) and two nuts (22) in support at left side

rear of engine. Install two screws (18) and two flat washers (19) in support at right side rear of

engine. Torque two screws (23) to 107-118 Ib-ft (150-165 N-m). Torque two screws (18) and

(20) to 22-24 Ib-ft (31-34 N·m).

2-78

WARNING