TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 113 of 596

TM 9-2815-205-34

2-32. ENGINE FROM/TO CONTAINER (MODELS 5063-5395, 5063-5398, AND 5063-539F

b. Installation

(1)

(2)

(3)

(4)

Install four screws (14), four flat washers (15), left mounting bracket (7), right mounting bracket

(8), and four self-locking nuts (16) on flywheel housing. Torque screws to 40-250 lb-ft

(325-339 N-m).

Install four screws (11), four flat washers (12), and engine mounting bracket (6) on front of

engine. Torque screws to 46-50 Ib-ft (62-68 N·m).

Never crawl under

equipment when performing maintenance unless equipment

is securely blocked. Keep clear of equipment when it is being raised or lowered.

Do not allow heavy components to swing while suspended by lifting device.

Exercise caution when working near a cable or a chain under tension.

Equipment may drop or shift and injury to personnel may result.

Attach beam-type sling (1) to lifting brackets (2) and install engine in lower half of container (10)

while aligning front mounting bracket (6) and two rear mounting brackets (7 and 8) to

suspension frame (9).

Install eight screws (3), eight flat washers (4), and eight self-locking nuts (5) through front

mounting bracket (6), two rear mounting brackets (7 and 8), and suspension frame (9). Torque

screws to 35-39 Ib-ft (47-53 N·m).

2-86

WARNING