TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 111 of 596
TM 9-2815-205-34
2-32. ENGINE FROM/TO CONTAINER (MODELS 5063-5395, 5063-5398, AND 5063-539F)
This task covers: a. Removal
b. Preservation
c. Installation
INITIAL SETUP
MODELS
TOOLS AND SPECIAL TOOLS (Cont)
5063-5395 5063-5398 5063-539F
Wrench, torque (App B, Item 116)
Wrench, torque (App B, Item 117)
TOOLS AND SPECIAL TOOLS
Tool set, general mechanics (App
B, Item 107)
EQUIPMENT CONDITION
Sling, beam-type (App B, Item 92)
Para Description
2-3 Container top removed.
PERSONNEL REQUIRED: 2
a. Removal
(1)
(2)
(3)
(4)
(5)
Attach beam-type sling (1) to engine lifting brackets (2) and support engine with lifting device.
Remove eight screws (3), eight flat washers (4), and eight self-locking nuts (5) connecting front
mounting bracket (6) and two rear mounting brackets (7 and 8) to suspension frame (9).
Never crawl under
equipment when performing maintenance unless
equipment
is securely blocked.
Keep clear of equipment when it is being raised or lowered.
Do not allow heavy components to swing while suspended by lifting device.
Exercise caution when working near a cable or a chain under tension.
Equipment may drop or shift and injury to personnel may result.
Remove engine from lower half of container (10).
Remove four screws (11), four flat washers (12), and engine mounting bracket (6) from front of
engine. Store screws, washers, and nuts in mailbag (13) in lower half of container (10).
Remove four screws (14), four flat washers (15), left mounting bracket (7), right mounting
bracket (8), and four self-locking nuts (16) from flywheel housing. Store screws, washers, and
nuts in mailbag in lower half of container (10).
CAUTION
Always install upper section of the container on the bottom section and seal container
(refer to Para 2-3) with bolts and nuts after the engine has been removed. This action is
necessary to avoid weather damage to interior of container.
2-84
WARNING
Back to Top
