TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 119 of 596
TM 9-2815-205-34
2-35. OIL FILTER ASSEMBLY REPAIR (ALL EXCEPT MODELS 5063-5393 AND 5063-539L)
This task covers: a. Disassembly
b. Cleaning/Inspection
c. Assembly
INITIAL SETUP
MODELS
MATERIALS/PARTS
All except models 5063-5393 5063-539L
1
Filter element (App F, Item 23)
1
Gasket App F, Item 78)
TOOLS AND SPECIAL TOOLS
1
Gasket App F, Item 29)
Tool kit, general mechanics (App B, Item 107)
Wrench, torque (App B, Item 116)
EXPENDABLE/DURABLE SUPPLIES
Cleaning solvent (App C, Item 9)
a. Disassembly
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
Remove drain plug (1) from bottom of oil filter cover (2).
Back out shoulder bolt (3) and separate filter head (4) from cover (2).
Remove gasket (5) from filter head (4). Discard gasket.
Remove oil filter element (6) from cover (2). Discard filter element,
Remove nut (7), retainer (8), preformed packing (9), spacer (10), and spring (11) from shoulder
bolt (3) in cover (2).
Remove shoulder bolt (3) from cover (2) and gasket (12) from shoulder bolt. Discard gasket.
For model 5063-5392: If necessary, remove two elbows (13) and two plugs (14) from filter head
(4) .
For models 5063-5395 and 5063-539F: If necessary, remove two pressure switches (15), two
elbows (16), two small bushings (17), and two large bushings (18) from filter head (4).
b. Cleaning/Inspection
●
●
(1)
(2)
2-92
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles
and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes. Do not breathe vapors. Do not use near open flame or excessive heat
The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy while
using cleaning solvent, get fresh air immediately and seek medical aid. If contact
with eyes is made, wash with water and get medical aid immediately.
Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with
effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.)
Clean parts with dry cleaning solvent and dry with compressed air.
Inspect all parts for damage and excessive wear. Replace as necessary.
Change 1
Back to Top
