TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 124 of 596

TM 9-2815-205-34

(2) Fuel secondary filter assembly (filter)

(a) Remove drain cock (9) from filter body

(10).

(b) Remove bolt (11), small gasket (12),

filter body (10), filter element (13), and

large gasket (14) from filter head (15).

Discard filter element and gaskets.

(c) Remove retaining ring (16), seat (17),

gasket (18), spring seat (19), and

spring (20) from filter body (10).

Discard gasket and retaining ring.

b. Cleaning/Inspection

• Dry cleaning solvent P-D-680

is toxic and flammable. Wear

protective goggles

and

gloves and use in a well-ven-

tiIated area. Avoid contact

with skin, eyes, and clothes.

Do not breathe vapors. Do

not use near open flame or

excessive heat. The flash

point Is 100-138 Degrees F

(38-50 Degrees C). If you be-

come dizzy while using

cleaning solvent, get fresh

air immediately and seek

medical aid. If contact with

eyes is made, wash with

water and get medical aid im-

mediately.

• Compressed air used for

exceed 30 PSI. Use only with

effective chip guarding and

personal protective equip-

ment

(goggles/shield,

gloves, etc.)

(1) Wash shell assembly and filter body

thoroughly with dry cleaning solvent and

dry with compressed air.

(2) Examine gasket in shell assembly for

cracks or hardening, replace if defective.

2-97

WA`RNING

cleaning purpose will not