TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 121 of 596

TM 9-2815-205-34

2-36. OIL FILTER ASSEMBLY REPAIR (MODELS 5063-5393 AND 5063-539L)

This task covers: a. Disassembly

b. Cleaning/Inspection

c. Assembly

INITIAL SETUP

MODELS

MATERIALS/PARTS

5063-5393 5063-539L

1

Element, spin-on, oil filter (App F,

Item 22)

TOOLS AND SPECIAL TOOLS

Tool kit, general mechanics (App B, Item 107)

EXPENDABLE/DURABLE SUPPLIES

Wrench, torque (App B, Item 116)

Cleaning solvent (App C, Item 9)

Wrench, oil filter (App B, Item 114)

Oil, engine (App C, Item 26)

a.

Disassembly

(1) Using an oil filter wrench, remove oil filter spin-on element (1) from adapter (2). Discard oil filter

element.

(2) If necessary, remove nipple (3) from adapter (2).

●

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. D

O

not breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy while

using cleaning solvent, et fresh air immediately and seek medical aid.

If

contact

with eyes is made, was with water and get medical aid immediately.

b. Cleaning/Inspection

(1)

(2)

●

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with

effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

Clean parts with dry cleaning solvent and dry with compressed air.

Inspect all parts for damage and excessive wear. Replace as necessary.

2-94

Change 1