TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 109 of 596
TM 9-2815-205-34
2-31. ENGINE FROM/TO CONTAINER (MODELS 5063-5299, 5063-5392, AND 5063-5393) (Cont)
NOT E
Screw installed in flywheel
housing at the eight o’clock po-
sition cannot be removed when
the oil filter adapter is installed
due to interference.
(8) Remove four short screws (22), two long
screws (23), two nuts (24), six
Iockwashers (25), and rear support (15)
from engine flywheel housing (26). Store
screws, washers, and nuts in mailbag (9).
Store mailbag and rear support in lower
half of container (10).
CAUTION
Always install top of container
on bottom of container (Para
2-3) after the engine has been
removed to avoid weather
damage of container.
b. Installation
WARNING
(1)
(2)
(3)
(4)
(5)
(6)
2-82
Never crawl under equipment when performing maintenance unless equipment
is securely blocked. Keep clear of equipment when it is being raised or lowered.
Do not allow heavy components to swing while suspended by lifting device.
Exercise caution when working near a cable or a chain under tension.
Equipment may drop or shift and injury to personnel may result.
Attach beam-type sling (1) to lifting brackets (2) and support engine with lifting device.
Install rear support (15), six Iockwashers (25), four short screws (22), two long screws (23), and
two nuts (24) on engine flywheel housing (26). Torque screws to 14-17 Ib-ft (19-23 N·m). All
screws, washers, and nuts are contained in mailbag (9).
For model 5063-5299, remove two screws (3), two Iockwashers (5), four flat washers (6), and
two nuts (4) from shipping trunnion assembly (7) in lower half of container. Store screws,
washers, and nuts in mailbag (9).
For model 5063-5299, remove two screws (18), two Iockwashers (19), and upper shipping
trunnion block (20) from lower shipping trunnion block (21). Remove preformed packing (17)
from lower shipping trunnion block and install on front of engine.
For model 5063-5299, install lower shipping trunnion block (21), upper shipping trunnion block
(20), two screws (18), and two Iockwashers (19) over preformed packing (17) on engine. Hand
tighten screws.
Install engine in lower half of container (10).
Back to Top
