TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 136 of 596

(5)

TM 9-2815205-34

Remove two screws (13), two lockwashers (14), screw (15), lockwasher (16), two screws (17),

two lockwashers (18), and support bracket (11) from flywheel housing. Discard lockwashers.

b.

c.

Inspection

Check for cracks on exhaust tube flanges and turbocharger support bracket.

Installation

(1)

(2)

(3)

(4)

(5)

Install support bracket (11), two lockwashers (14), two small screws (13), lockwasher (1 6),

screw (15), two lockwashers (18), and two large screws (17) on flywheel housing. Torque

screws (13) to 30-35 lb-ft (41-47 NŽm), screw (15) to 46-50 lb-ft (62-68 NŽm), and screws (17) to

71-75 lb-ft (96-102 NŽm).

If removed, install four studs (12) in exhaust tee (5).

Loosely install exhaust tee (5), three lockwashers (10), and three screws (9) on support bracket

(11). Do not tighten screws.

Install exhaust tube (6), exhaust tube (7), and four couplings (8) between exhaust manifolds

(19) and exhaust tee (5).

NOTE

Align exhaust tubes and exhaust tee properly before tightening couplings and exhaust

tee fastening screws.

Alternately tighten couplings (8) and screws (9). Torque screws to 30-35 lb-ft (41-47 NŽm).

Tighten couplings until springs are completely compressed.

3-11