TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 134 of 596

TM 9-2815-205-34

b. Inspection

Check for cracks on exhaust tube flanges.

c. Installation

(1) If removed, install four studs (9) in exhaust tee (7).

(2) Install right exhaust tube (5), left exhaust tube (6), exhaust tee (7), and four couplings (8) on

exhaust manifolds (10). Tighten couplings until springs are completely compressed.

(3) Install insulator set (2) on exhaust tube (5), insulator set (3) on exhaust tube (6), and insulator

set (4) on exhaust tee (7). Fasten insulator sets together using wire (1) and wire-twister pliers

as follows:

(a) Loop wire around first capstand (11) and apply two twists using wire-twister pliers.

(b)

(c)

(d)

While holding insulator set in place by hand, place ends of wire on each side of adjacent

capstand (12) and apply at least two more twists using wire-twister pliers.

Trim wire 3/4 inch (20 mm) from second capstand.

Repeat for remaining pairs of capstands on insulator sets.

END OF TASK

FOLLOW-ON MAINTENANCE

Para Description

3-2 Install turbocharger.

3-9