TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 417 of 596

TM 9-2815-205-34

b. Cleaning/inspection

WARNING

•

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. D

O

not use near open flame or excessive heat.

The flash point is 100-138°F (38-50°C). If you become dizzy while using cleaning

solvent, get fresh air Immediately and seek medical aid. If contact with eyes is

made, wash with water and get medical aid immediately.

•

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only

with effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

CAUTION

Do not wash bearing

bly. Cleaning solvent

assem-

will dis-

solve internal grease and

destroy bearing assembly.

(1)

(2)

(3)

(4)

c. Assembly

Wash all components, except bearing

and shaft assembly, in cleaning solvent

and dry with compressed air.

Wipe bearing and shaft assembly with

clean wiping rag.

Discard bearing if it has a general feeling

of roughness, is tight, or is damaged.

Inspect ceramic insert for cracks,

scratches, and loss of bond to impeller

(12).

(1)

CAUTION

Do not press shaft into bearing

assembly. Pressure on shaft

will distort bearings and de-

stroy bearing assembly.

Place bearing inserter (9) against outer

race of shaft and bearing assembly (10)

and press into pulley side of pump

housing (13) until outer race of bearing is

flush with outer face of housing.

3-287