TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 425 of 596

TM 9-2815-205-34

CAUTION

(15)

(16)

(17)

(18)

(19)

(20)

Inspect fuse plug (38). If fuse plug is melted, cylinder head assembly was overheated.

Thoroughly inspect cylinder head assembly for cracks and other heat related damage.

NOT E

Pressure check cylinder head

at this point as described in

step c.

Models

5063-5395,

5063-

5398, and 5063-539F do not

use cover (39) and fastening

hardware on rear of right

cylinder head assembly.

Remove two screws (40), two Iockwashers

(41), cover (39), and gasket (42) from rear

of cylinder head. Discard Iockwashers and

gasket.

If necessary, remove four studs (43) from

outboard side of cylinder head.

Remove fuse plug (38) and adapter (44)

from outboard side of cylinder head.

Remove three expansion plugs (45) from

outboard side of cylinder head, Discard plugs.

Remove four pipe plugs (46) from inboard

side of cylinder head.

Remove pipe plug (47) from each

cylinder head.

NOT E

Models

5063-5395,

5063-

5398, 5063-5392, and 5063-

539F use one threaded plug

(48) at rear of left cylinder head.

Models

5063-5393,

and

5063-539L uses one threaded

plug (48) at both ends of left cyl-

inder head.

end of

Models

5063-5395,

5063-

5398, and 5063-539F, use two

threaded plugs (48) at inboard

side of right cylinder head.

(21) If necessary, remove six threaded plugs (48), except where noted, from each end of head. Two

plugs are located at each end and four plugs are located on inboard side of cylinder head.

Change 1

3-295