TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 437 of 596

(8)

(9)

(10)

NOT E

Models 5063-5395, 5063-5398, 5063-5392, and

(48) at rear of left cylinder head.

TM 9-2815-205-34

5063-539F use one threaded plug

Models 5063-5393 and 5063-539L uses one threaded plug (48) at both ends of left

cylinder head.

Models 5063-5395, 5063-5398, and 5063-539F use two threaded plugs (48) at inboard

side of right cylinder head.

If removed, install six threaded plugs (48), except where noted, in cylinder head. One plug

located at each end and four plugs located in inboard side of cylinder head.

If any exhaust manifold stud (43) was removed, apply sealing compound to threads of stud and

install in outboard side of cylinder head. Torque stud to 25-40 Ib-ft (34-54 N·m). Stud must

protrude 1 7/16-1 1/2 inches (3.5-3.8 cm) from face of cylinder head.

Install six fuel nipples (3) and six copper

washers (35) to fuel galleries at top of

cylinder head. Torque connectors to 20-28

lb-ft (27-38 N•m).

NOT E

ModeIs 5063-5395,

5398. and 5063-539F

5063-

do not

use cover (39) and fastening

hardware on the rear right cylin-

der head assembly.

(11)

Install gasket (42), cover (39), two

lockwashers (41), and two bolts (40) on

rear of cylinder head.

Change 1

3-307