TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 441 of 596

TM 9-2815-205-34

NOT E

If a new rocker arm is installed,

also install a new push rod.

Push rod nut adjustment is

(27)

(28)

(29)

performed during engine tune-

up (para 4-4).

Thread each rocker arm (13, 14, and 15)

on its push rod (20) assembly until end of

push rod is flush with inner side of clevis

yoke (91).

CAUTION

Injector hold-down clamp must

not contact exhaust valve

spring or injector follower

spring.

Install three fuel injectors (2), three

clamps (18), three convex washers (17),

and three screws (16) in cylinder head.

Install convex washers with curved side

toward injector clamp. Align dowel pin in

injector with hole in cylinder head. Torque

screws to 20-25 Ib-ft (27-34 N·m).

For all except model 5063-5299: if

necessary, install check valve (10),

strainer (12), and oil supply plug (11) into

throttle delay housing (9).

3-311