TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 223 of 968

TM 9-2815-210-34-2-2

FRAME 6

1.

2.

3.

4.

5.

6.

NOTE

Readings must be within limits given in table 4-46. The

letter L shows a loose fit.

If readings are not within

given limits, throw away part and get a new one.

Measure free length of piston cooling relief valve plunger spring (1).

Using spring tester, measure load needed to squeeze spring (1) down

to 1.380 inches.

Using spring tester, measure solid height of spring (1).

Measure outside diameter of two plungers (2).

Measure inside diameter of two plunger bores (3).

Measure fit of two plungers (2) in plunger bores (3).

END OF TASK

NOTE: CHECK ONLY THOSE PARTS WHICH ARE CALLED OUT IN

THIS FRAME. PARTS WITHOUT CALLOUTS ARE SHOWN

ONLY FOR REFERENCE PURPOSES OR ARE CHECKED IN

ANOTHER FRAME.

TA 101246

4-204