TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 271 of 968

TM 9-2815-210-34-2-2
d .
Assembly.
FRAME 1
1.
2.
3.
NOTE
Valves must be put back in cylinder head (1) in the
same place they were taken from.
Task shown is for an exhaust valve (2). Task is the
same for intake valves.
Put exhaust valve (2) through exhaust valve guide (3) in cylinder head (1)
as shown.
Put valve rotor (4) over valve stem (5) and slide it all the way in. Spring
seat side of rotor should face outward as shown.
NOTE
Outer valve spring (6) must be put back so that end
with tightly wound coils faces cylinder head (1).
Put inner valve spring (7) over valve stem (5). Put outer valve spring (6)
over inner valve spring.
GO TO FRAME 2
4-252


Back to Top