TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 278 of 968

TM 9-2815-210-34-2-2

b .

Cleaning.

FRAME 1

1.

2.

WARNING

Dry cleaning solvent is flammable. Do not use near

an open flame.

Keep a fire extinguisher nearby when

solvent is used.

Use only in well-ventilated places.

Failure to do this may result in injury to personnel

and damage to equipment.

Clean six rocker arms (1), six valve adjusting screws (2), six valve adjusting

nuts (3), three rocker arm shaft supports (4), two retaining rings (5), two

thrust washers (6), two thrust springs (7), six mounting bolts (8), six lock-

washers (9), two plugs (10), and rocker arm shaft (11) in dry cleaning solvent,

Clean off sludge and gum deposits with a stiff brush. Dry with clean rags.

WARNING

Eye shields must be worn when using compressed air.

Eye injury can occur if eye shields are not used.

Clean out all oil passages in six rocker arms (1), front and rear rocker arm

shaft supports (4), and rocker arm shaft (11) using brass wire probes. Flush

all oil passages with dry cleaning solvent.

Blow all oil passages dry with com-

pressed air.

END OF TASK

4-259