TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 287 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

4.

5.

6.

NOTE

Rear end of rocker arm shaft (1) has locating dowel

pin (2).

Make sure you put rocker arm shaft supports (3 and 4)

rocker arm assemblies (5 and 6), and rear thrust spring

(7) on rocker arm shaft (1) as tagged.

Put in two plugs (8) one in each end of rocker arm shaft (1).

Hold rocker arm shaft (1) so that locating dowel pin (2) at rear of rocker arm

shaft points down.

Slide rear rocker arm shaft support (3) over front end of

rocker arm shaft and push it as far back on shaft as it will go. Locating

dowel pin must fit in notch of rear rocker arm shaft support.

Slide rear intake valve rocker arm assembly (5) over front end of rocker arm

shaft (1) and push it all the way back.

Slide rear rocker arm thrust spring (7) over front end of rocker arm shaft (1

and push it all the way back as shown.

Slide center intake valve rocker arm assembly (6) over front end of rocker

arm shaft (1) and push it all the way back.

Slide center rocker arm shaft support (4) over front of rocker arm shaft (1)

and push it all the way back as shown.

GO TO FRAME 3

4-268