TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 288 of 968

TM 9-2815-210-34-2-2

FRAME 3

1.

2.

3.

4.

5.

NOTE

Make sure front rocker arm shaft support (1), rocker arm

assemblies (2, 3, and 4), and front thrust spring (5) are

put back on rocker arm shaft (6) as tagged.

Slide center intake valve rocker arm assembly (2) over front end of rocker

arm shaft (6) and push it all the way back.

Slide front thrust spring (5) over front of rocker arm shaft (6) and Push it

all the way back.

Slide front exhaust valve rocker arm assembly

shaft (6) and push it all the way back.

NOTE

You will have to squeeze down thrust

to fit rest of parts on front of rocker

(3) over front of rocker arm

springs (5 and 7)

arm shaft (6).

Slide front rocker arm shaft support (1) over front of rocker arm shaft (6)

and push down thrust springs (5 and 7) so there is enough room at front of

rocker arm shaft for front exhaust valve rocker arm assembly (4).

Slide front intake valve rocker arm assembly (4) over front of rocker arm

shaft (6) and push it down against thrust springs (5 and 7). Put on thrust

washer (8) and retaining ring (9).

GO TO FRAME 4

4-269