TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 282 of 968

TM 9-2815-210-34-2-2

FRAME 4

1.

2.

3.

4.

Check that rocker arm shaft (1) is not cracked or broken. If rocker arm

shaft is cracked or broken, throw it and rocker arm supports (2) away and

get new ones.

CAUTION

It is easy to damage

what you are doing.

you are experienced

person with you.

the equipment if you do not know

Do not try to do this task unless

at it, or you have an experienced

NOTE

Bearing surfaces of rocker arm shaft (1) are surfaces

next to oil holes in rocker arm shaft.

Check that rocker arm shaft (1) does not have worn bearing surfaces and that

rocker arm shaft is not scored.

If rocker arm shaft is scored or has worn bear-

ing surfaces, throw it and rocker arm supports (2) away and get new ones.

Check that locating dowel pin (3) is not cracked, chipped or loose. If it is

damaged or loose, throw away rocker arm shaft (1) and locker arm supports

(2) and get new ones.

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame.

Keep a fire extinguisher nearby when sol-

vent is used.

Use only in well-ventilated places. Fail-

ure to do this may result in injury to personnel and

damage to equipment.

Check that rocker arm shaft (1) has no small nicks, scratches or burrs. Fix

small nicks, scratches or burrs with a crocus cloth dipped in dry cleaning

solvent.

GO TO FRAME 5

4-263