TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 283 of 968

TM 9-2815-210-34-2-2

FRAME 5

NOTE

Readings must be within limits given in table 4-57.

The letter L shows a loose fit.

If readings are not

within given limits, throw away part and get a new

one.

Rear end of rocker arm shaft (1) has a locating dowel

pin (2).

Rocker arm bearing surfaces of rocker arm shaft (1) are

surface areas near the first, third, fourth, fifth, sixth,

and eighth oil holes in rocker arm shaft, counting from

front to rear.

Bearing surfaces will look shiny on used

rocker arm shafts.

1.

Measure inside diameter of six rocker arm bearings (3). Note each measurement

and which rocker arm it was taken on.

2.

Measure outside diameter of six rocker

shaft (1).

Note each measurement and

was taken on.

3.

Measure fit of each rocker arm bearing

arm shaft (1).

arm bearing surfaces of rocker arm

which rocker arm bearing surface it

(3) on its bearing surface of rocker

4.

Measure length A of six valve adjusting screws (4).

GO TO FRAME 6

4-264