TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 272 of 968

TM 9-2815-210-34-2-2

FRAME 2

1.

2.

3.

4.

5.

Put spring retainer (1) over outer valve spring (2) as shown. Using valve

spring compressor, squeeze spring retainer against springs so that groove

(3) in valve stem (4) sticks through hole in spring retainer.

Put two spring retainer locks (5) over groove (3) in valve stem (4) and hold

retainer locks together.

While holding retainer locks (5) together, slowly work valve spring

compressor to let all tension off valve springs (2).

CAUTION

Be sure spring pressure is holding retainer locks (5)

in place in groove on valve stem before letting go of

retainer locks.

If retainer locks are not locked to

valve stem, assembly may fly apart when retainer

locks are let go and parts will be lost.

Let go of retainer locks (5).

Take off valve spring compressor.

Do frames 1 and 2 again for other two exhaust valves and for three intake

valves.

END OF TASK

4-253