TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 416 of 968

TM 9-2815-210-34-2-2
FRAME 2
1.
Put nozzle and holder assembly (1) in soft-jawed vise. Tighten locknut (2)
to 40 to 45 pound-feet.
Take nozzle and holder assembly out of vise.
2.
Do nozzle opening pressure test, para 4-40a (1). If adjustment is not right,
do frame 1 and step 1 of this frame.
If adjustment is still not right, disassemble
clean and inspect, and repair nozzle. Refer to para 4-40b, c, and d.
3.
Put nozzle and holder assembly (1) in soft-jawed vise. Hold locknut (2) and
tighten cap (3) to 40 to 45 pound-feet.
Take nozzle and holder assembly out
of vise.
END OF TASK
4-397


Back to Top