TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

  TM-9-2815-210-34-2-2 - Page 68 of 968

TM 9-2815-210-34-2-2
FRAME 3 1
1.
2.
3.
NOTE
Four different crankshafts (2) can be used in these en-
gines.
They differ in the diameters of the main bearing
journals and connecting rod journals. The four crank-
shafts are:
early model standard size, late model stand-
ard
size,
0.0100-inch
undersize,
and
0.0200-inch
under-
size.
Look at flywheel mounting face (1) of crankshaft (2). If no number is
stamped here, this is a standard size crankshaft. Note this for future use.
Look at flywheel mounting face (1) of crankshaft (2). If the number 0.010
or 0.0100 is stamped here, this is a 0.0100-inch undersize crankshaft. Note
this for future use.
Look at flywheel mounting face (1) of crankshaft (2). If the number 0.020
or 0.0200 is stamped here, this is a 0.0200-inch undersize crankshaft. Note
this for future use.
IF CRANKSHAFT (2) WAS CHANGED DURING THIS TASK, GO TO FRAME 32.
IF CRANKSHAFT (2) WAS NOT CHANGED DURING THIS TASK, GO TO FRAME 34
4-49


Back to Top