TM-9-2815-210-34-2-2
ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER
TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2
APRIL 1981
TM-9-2815-210-34-2-2 - Page 67 of 968
TM 9-2815-210-34-2-2
Table 4-10. Crankshaft Thrust Bearing Journal, Crankshaft Pulley End,
Crankshaft Gear, and Crankshaft Damper and Pulley Wear Limits
Size and Fit
Index
of New Parts
Wear Limit
Number
Item/Point of Measurement
(inches)
(inches)
3
Crankshaft main thrust bearing
journal width
2.1370 to 2.1390
2.1420
5
Crankshaft pulley end rear
outside diameter
2.2492 to 2.2498
None
6
Crankshaft gear inside diameter
2.2495 to 2.2500
None
7 and 5
Fit of crankshaft gear on rear
of crankshaft pulley end
0.0003T to 0.0008L
None
8
Crankshaft damper and pulley
bore diameter
Late model
2.2478 to 2.2484
None
Early model
2.2487 to 2.2494
None
10
Crankshaft pulley end front
outside diameter
2.2487 to 2.2492
None
9 and 10
Fit of crankshaft damper and
pulley on front of crankshaft
pulley end
Late model
0.0003T to 0.0014T
None
Early model
0.007L to 0.005T
0.0014T
4-48
Back to Top
