TM-9-2815-210-34-2-2

ENGINE ASSEMBLY, DIESEL (MULTIFUEL): NATURALLY ASPIRATED OR TURBOCHARGED, FUEL-INJECTED, WATER-COOLED, 6-CYLINDER

TECHNICAL MANUAL; TROUBLESHOOTING; DIRECT SUPPORT AND GENERAL SUPPORT LEVEL; VOLUME 2 OF 2; PART 2 OF 2

APRIL 1981

TM-9-2815-210-34-2-2 - Page 711 of 968

TM 9-2815-210-34-2-2

FRAME 2

Soldiers

A and B

Soldier A

Soldier B

WARNING

Flywheel (1) is very heavy. It should be lifted into

place by two persons.

After flywheel is in position,

it must be held firmly until mounting bolts are put in.

Failure to do so may cause injury to personnel and

damage to equipment.

CAUTION

Mating surfaces of crankshaft flange (2) and flywheel

(1) must be clean and free of raised metal which could

keep flywheel from being properly seated.

1.

Lift flywheel (1) and flexible plates (3) up to flywheel

housing (4).

2.

Aline scribe marks on flywheel (1) and flexible plates (3) and

slide them onto pilot bolt (5).

3.

Hold flywheel (1) and flexible plates (3) in

puts in five mounting lockbolts (6).

4.

Coat six lockbolts (6) with engine oil. Put

place while soldier B

on scuff plate (7).

Put in and hand tighten five lockbolts.

5.

Take out pilot bolt (5).

Put in and hand tighten other lockbolt

(6) .

GO TO FRAME 3

5-82